Journal of Shanghai Jiao Tong University ›› 2021, Vol. 55 ›› Issue (9): 1134-1141.doi: 10.16183/j.cnki.jsjtu.2020.028

Special Issue: 《上海交通大学学报》2021年“无线电电子学与电信技术”专题 《上海交通大学学报》2021年12期专题汇总专辑

Previous Articles     Next Articles

Impact of Continuous RESET/SET Operations on Endurance Characteristic of Phase Change Memory

WU Lei1,2, CAI Daolin1(), CHEN Yifeng1, LIU Yuanguang1,2, YAN Shuai1,2, LI Yang1,2, YU Li1,2, XIE Li1, SONG Zhitang1   

  1. 1. Shanghai Institute of Microsystem and Information Technology; State Key Laboratory of Functional Materials for Informatics; Laboratory of Nanotechnology, Chinese Academy of Sciences, Shanghai 200050, China
    2. University of Chinese Academy of Sciences, Beijing 100049, China
  • Received:2020-01-22 Online:2021-09-28 Published:2021-10-08
  • Contact: CAI Daolin E-mail:caidl@mail.sim.ac.cn

Abstract:

In order to explore the effects of continuous RESET operations and continuous SET operations on the endurance characteristic of phase change memory (PCM), the endurance characteristics of PCM at different ratios of RESET-SET times are studied based on a 4Mbit PCM chip. The variation of resistance distributions of PCM after continuous RESET and continuous SET operations are measured. The endurance characteristics of PCM in RESET-only and SET-only operations are compared with the typical endurance characteristic. Besides, the causes and repair methods of failure are also discussed. Moreover, the endurance characteristics of PCM at 8 different RESET-SET ratios are compared. The research results show that continuous RESET operation has little effect on the endurance characteristic of PCM, and the endurance characteristic of PCM in the RESET-only mode is on the same order as the typical endurance characteristic. However, the continuous SET operation has a significantly destructive effect on the endurance characteristic of PCM, and the endurance characteristic of PCM in the SET-only mode is 2 orders of magnitude lower than the typical endurance characteristic. The failure process of PCM caused by continuous RESET operation is irreversible while the failure process of PCM caused by continuous SET operation can be repaired by intermittent RESET operation.

Key words: phase change memory (PCM), continuous RESET operation, continuous SET operation, endurance characteristic, failure improvement

CLC Number: