上海交通大学学报(自然版) ›› 2014, Vol. 48 ›› Issue (06): 788-792.
收稿日期:
2013-09-29
出版日期:
2014-06-30
发布日期:
2014-06-30
Received:
2013-09-29
Online:
2014-06-30
Published:
2014-06-30
摘要:
中图分类号:
张如许1,胡海涛2,庄大伟2,丁国良2,向量3,魏文建3. 板式换热器内两相流流量分配的模拟及实验验证[J]. 上海交通大学学报(自然版), 2014, 48(06): 788-792.
ZHANG Ruxu1,HU Haitao2,ZHUANG Dawei2,DING Guoliang2,. Simulation and Experimental Validation of Two-Phase Flow Distribution in Plate Heat Exchanger[J]. Journal of Shanghai Jiaotong University, 2014, 48(06): 788-792.
[1]赵晓文, 苏俊林. 板式换热器的研究现状及进展[J]. 冶金能源, 2011, 30(1): 5255. ZHAO Xiaowen, SU Junlin. Research status and development of the plate heat exchangers[J]. Energy for Metallurgical Industry, 2011, 30(1): 5255. [2]Bobbili P R, Sunden B, Das S K. Thermal analysis of plate condensers in presence of flow maldistribution[J]. International Journal of Heat and Mass Transfer, 2006, 49(25): 49664977. [3]Bobbili P R, Sunden B. Pressure drop in multiparallel channels of corrugated plate steam condensers[J]. Heat Transfer Engineering, 2009,30(13): 10241032. [4]仇嘉, 魏文建, 张绍志, 等. 基于 CFD 数值模拟的板式换热器分配器性能研究[J]. 机械工程学报, 2010, 46(14): 130137. QIU Jia, WEI Wenjian, ZHANG Shaozhi, et al. Research on performance of distributors used in Plate heat exchangers based on CFD numerical simulation[J]. Journal of Mechanical Engineering, 2010, 46(14): 130137. [5]Bassiouny M K, Martin H. Flow distribution and pressure drop in plate heat exchangers—Ⅰ Utype arrangement[J]. Chemical Engineering Science, 1984, 39(4): 693700. [6]Ablanque N, Oliet C, Rigola J, et al. Twophase flow distribution in multiple parallel tubes[J]. International Journal of Thermal Sciences, 2010, 49(6): 909921. [7]Han D H, Lee K J, Kim Y H. Experiments on the characteristics of evaporation of R410A in brazed plate heat exchangers with different geometric configurations[J]. Applied Thermal Engineering, 2003, 23(10): 12091225. [8]Hsieh Y Y, Lin T F. Saturated flow boiling heat transfer and pressure drop of refrigerant R410A in a vertical plate heat exchanger[J]. International Journal of Heat and Mass Transfer, 2002, 45(5): 10331044. [9]Longo G A, Gasparella A. HFC410A vaporisation inside a commercial brazed plate heat exchanger[J]. Experimental Thermal and Fluid Science, 2007, 32(1): 107116. [10]邱峰, 曾伟平, 谷波. R410A的板式蒸发器换热与压降分析[J]. 上海交通大学学报, 2009,43(10): 16121615. QIU Feng, ZENG Weiping, GU Bo. Heat transfer and pressure drop analysis on evaporation of refrigerant R410A in plate heat exchanger[J]. Journal of Shanghai Jiaotong University, 2009,43(10): 16121615. [11]Hwang S T, Soliman H M, Lahey Jr R T. Phase separation in dividing twophase flows[J]. International Journal of Multiphase Flow, 1988, 14(4): 439458. [12]Tae S J, Cho K. Twophase split of refrigerants at a Tjunction[J]. International Journal of Refrigeration, 2006, 29(7): 11281137. [13]Azzopardi B J, Whalley P B. The effect of flow patterns on twophase flow in a T junction[J]. International Journal of Multiphase Flow, 1982, 8(5): 491507. [14]Roberts P A, Azzopardi B J, Hibberd S. The split of horizontal annular flow at a Tjunction[J]. Chemical Engineering Science, 1997, 52(20): 34413453. [15]Azzopardi B J. The effect of the side arm diameter on the twophase flow split at a “T” junction[J]. International Journal of Multiphase Flow, 1984, 10(4): 509512. [16]魏文建, 李华. 点波板式换热器内流体流动换热及压降特性的实验研究[J]. 制冷技术, 2012, 32(4): 3641. WEI Wenjian, LI Hua. Experimental investigation of heat transfer and pressure drop characteristics of fluid flow in dimple plate heat exchanger[J]. Chinese Jounal of Refrigeration Technology, 2012, 32(4): 3641. |
[1] | 王志伟, 何炎平, 李铭志, 仇明, 黄超, 刘亚东. 基于计算流体力学的90° 弯管气液两相流数值模拟及流型演化[J]. 上海交通大学学报, 2022, 56(9): 1159-1167. |
[2] | 郭涛, 刘明明, 曹蕾, 胡京招, 洪国军, 尤云祥. 疏浚泵内泥沙颗粒的瞬态追踪数值方法[J]. 上海交通大学学报, 2022, 56(5): 656-663. |
[3] | 刘勖诚, 谷波, 曾炜杰, 杜仲星, 田镇. 小通道内制冷剂两相流动摩擦压降关联式分析[J]. 上海交通大学学报, 2021, 55(9): 1095-1107. |
[4] | 李岩松, 丁鼎倩, 韩东, 刘静, 梁永图. 起伏输油管道临界完全携积水油速数值模拟[J]. 上海交通大学学报, 2021, 55(7): 878-890. |
[5] | 李煜, 程广益, 李宗阳, 窦怡彬, 蒋君庭. 固体火箭发动机喷管两相流动下的热固耦合研究[J]. 空天防御, 2020, 3(1): 1-9. |
[6] | 谢行,任慧龙,陶凯东,冯亿坤. 应用改进流体体积法的楔形体斜向入水研究[J]. 上海交通大学学报, 2020, 54(1): 20-27. |
[7] | 王雨风,王丹东,胡记超,陈亮,陈江平. 两相流CO2喷射器内部流场的数值模型[J]. 上海交通大学学报, 2019, 53(7): 860-865. |
[8] | 邹良旭,马非,孟昭男,张鹏. 基于群体平衡模型的冰浆流动与传热特性数值研究[J]. 上海交通大学学报, 2019, 53(12): 1459-1465. |
[9] | 唐宜家, 马天寿, 何玉发, 陈平. 深水井筒两相流温度分布计算方法研究[J]. 海洋工程装备与技术, 2018, 5(增刊): 204-208. |
[10] | 邹旭毛,李良星,孔刘波,王华胜. 颗粒堆积床内两相流动阻力及相间摩擦力[J]. 上海交通大学学报(自然版), 2017, 51(4): 470-. |
[11] | 刘勇1,陈炉云2. 涡激振动对管道液固两相流流场的影响[J]. 上海交通大学学报(自然版), 2017, 51(4): 485-. |
[12] | 吴维武, 王东宝, 赵黎明, 袁振钦. 印刷电路板式LNG气化器换热试验研究[J]. 海洋工程装备与技术, 2016, 3(1): 20-24. |
[13] | 梅登飞,范浩杰,田凤国,崔璇,章明川. 黏性与非黏性颗粒在流化床中的气泡行为模拟[J]. 上海交通大学学报(自然版), 2015, 49(05): 577-582. |
[14] | 李文升, 郭烈锦, 李乃良, 程兵, 姚海元. 集输-S型立管中空气-油两相流流型特征实验研究[J]. 海洋工程装备与技术, 2014, 1(1): 30-34. |
[15] | 王小川a,b,贺国a,c,郭朝有b,李雁飞b. 旋流强度对气/雾两相传热传质的影响[J]. 上海交通大学学报(自然版), 2013, 47(11): 1767-1772. |
阅读次数 | ||||||||||||||||||||||||||||||||||||||||||||||||||
全文 241
|
|
|||||||||||||||||||||||||||||||||||||||||||||||||
摘要 991
|
|
|||||||||||||||||||||||||||||||||||||||||||||||||