板式换热器内两相流流量分配的模拟及实验验证

上海交通大学学报（自然版） ›› 2014, Vol. 48 ›› Issue (06): 788-792.

板式换热器内两相流流量分配的模拟及实验验证

张如许1，胡海涛2，庄大伟2，丁国良2，向量3，魏文建3

（1.上海电气电站工程公司，上海 201199； 2.上海交通大学制冷与低温工程研究所，上海 200240；3.丹佛斯换热器中国研发中心，浙江嘉兴 314300）

收稿日期:2013-09-29 出版日期:2014-06-30 发布日期:2014-06-30

Simulation and Experimental Validation of Two-Phase Flow Distribution in Plate Heat Exchanger

ZHANG Ruxu1，HU Haitao2，ZHUANG Dawei2，DING Guoliang2，XIANG Liang3，WEI Wenjian3

(1.Shanghai Electric Power Generation Engineering Company, Shanghai 201199， China;2.Institute of Refrigeration and Cryogenics, Shanghai Jiaotong University, Shanghai 200240, China;3.Danfoss Heat Exchanger China Research and Dvelopment Center, Jiaxing 314300, Zhejiang, China)

Received:2013-09-29 Online:2014-06-30 Published:2014-06-30

摘要/Abstract

摘要：

针对带有分配器的钎焊板式换热器内各支路的气液流量分配特性建立了预测模型.基于各支路的压降平衡方程，分别建立了板间流道和分配器流道压降计算模型；基于分配器处的气液分离关系方程，分别建立了两相流体在分配器处相分离和在分配器入口处液膜分布的计算模型.通过将压降平衡方程、气液分离方程分开迭代计算，开发了适用于模型的求解算法.模拟结果与实验测试数据对比表明，换热器总压降的相对误差在±20%以内，两相区高度的相对误差在±13%以内.

关键词: 板式换热器, 两相流, 气液分配

Abstract:

A mathematic model was developed in this paper to predict the two-phase flow distribution characteristics in a plate heat exchanger. The submodels of the pressure drops in both the channel and the distributor were established based on pressure balance equations. The submodels of both the phase split in distributor and the liquid film distribution in the inlet of distributor were established based on phase separation equations. The algorithm of the mathematical model was developed by interatively solving the pressure drop balance equations and the phase separation equations respectively. The predictions of the model were compared with the experimental data. The relative errors of pressure drop between mathematic model and experimental data are within ±20%. The relative errors of two-phase region height between mathematic model and experimental data are within ±13%.

Key words: plate heat exchanger, two-phase flow, gas-liquid distribution

中图分类号:

TB 657.5

张如许1，胡海涛2，庄大伟2，丁国良2，向量3，魏文建3. 板式换热器内两相流流量分配的模拟及实验验证[J]. 上海交通大学学报（自然版）, 2014, 48(06): 788-792.

ZHANG Ruxu1，HU Haitao2，ZHUANG Dawei2，DING Guoliang2，. Simulation and Experimental Validation of Two-Phase Flow Distribution in Plate Heat Exchanger[J]. Journal of Shanghai Jiaotong University, 2014, 48(06): 788-792.

参考文献

［1］赵晓文, 苏俊林. 板式换热器的研究现状及进展［J］. 冶金能源, 2011, 30(1): 5255.

ZHAO Xiaowen, SU Junlin. Research status and development of the plate heat exchangers［J］. Energy for Metallurgical Industry, 2011, 30(1): 5255.

［2］Bobbili P R, Sunden B, Das S K. Thermal analysis of plate condensers in presence of flow maldistribution［J］. International Journal of Heat and Mass Transfer, 2006, 49(25): 49664977.

［3］Bobbili P R, Sunden B. Pressure drop in multiparallel channels of corrugated plate steam condensers［J］. Heat Transfer Engineering, 2009,30(13): 10241032.

［4］仇嘉, 魏文建, 张绍志, 等. 基于 CFD 数值模拟的板式换热器分配器性能研究［J］.

机械工程学报, 2010, 46(14): 130137.

QIU Jia, WEI Wenjian, ZHANG Shaozhi, et al. Research on performance of distributors used in Plate heat exchangers based on CFD numerical simulation［J］. Journal of Mechanical Engineering, 2010, 46(14): 130137.

［5］Bassiouny M K, Martin H. Flow distribution and pressure drop in plate heat exchangers—Ⅰ Utype arrangement［J］. Chemical Engineering Science, 1984, 39(4): 693700.

［6］Ablanque N, Oliet C, Rigola J, et al. Twophase flow distribution in multiple parallel tubes［J］. International Journal of Thermal Sciences, 2010, 49(6): 909921.

［7］Han D H, Lee K J, Kim Y H. Experiments on the characteristics of evaporation of R410A in brazed plate heat exchangers with different geometric configurations［J］. Applied Thermal Engineering, 2003, 23(10): 12091225.

［8］Hsieh Y Y, Lin T F. Saturated flow boiling heat transfer and pressure drop of refrigerant R410A in a vertical plate heat exchanger［J］. International Journal of Heat and Mass Transfer, 2002, 45(5): 10331044.

［9］Longo G A, Gasparella A. HFC410A vaporisation inside a commercial brazed plate heat exchanger［J］. Experimental Thermal and Fluid Science, 2007, 32(1): 107116.

［10］邱峰, 曾伟平, 谷波. R410A的板式蒸发器换热与压降分析［J］. 上海交通大学学报, 2009，43(10): 16121615.

QIU Feng, ZENG Weiping, GU Bo. Heat transfer and pressure drop analysis on evaporation of refrigerant R410A in plate heat exchanger［J］. Journal of Shanghai Jiaotong University, 2009，43(10): 16121615.

［11］Hwang S T, Soliman H M, Lahey Jr R T. Phase separation in dividing twophase flows［J］.

International Journal of Multiphase Flow, 1988, 14(4): 439458.

［12］Tae S J, Cho K. Twophase split of refrigerants at a Tjunction［J］. International Journal of Refrigeration, 2006, 29(7): 11281137.

［13］Azzopardi B J, Whalley P B. The effect of flow patterns on twophase flow in a T junction［J］. International Journal of Multiphase Flow, 1982, 8(5): 491507.

［14］Roberts P A, Azzopardi B J, Hibberd S. The split of horizontal annular flow at a Tjunction［J］.

Chemical Engineering Science, 1997, 52(20): 34413453.

［15］Azzopardi B J. The effect of the side arm diameter on the twophase flow split at a “T” junction［J］.

International Journal of Multiphase Flow, 1984, 10(4): 509512.

［16］魏文建, 李华. 点波板式换热器内流体流动换热及压降特性的实验研究［J］. 制冷技术, 2012, 32(4): 3641.

WEI Wenjian, LI Hua. Experimental investigation of heat transfer and pressure drop characteristics of fluid flow in dimple plate heat exchanger［J］. Chinese Jounal of Refrigeration Technology, 2012, 32(4): 3641.

[1]	王志伟, 何炎平, 李铭志, 仇明, 黄超, 刘亚东. 基于计算流体力学的90° 弯管气液两相流数值模拟及流型演化[J]. 上海交通大学学报, 2022, 56(9): 1159-1167.
[2]	郭涛, 刘明明, 曹蕾, 胡京招, 洪国军, 尤云祥. 疏浚泵内泥沙颗粒的瞬态追踪数值方法[J]. 上海交通大学学报, 2022, 56(5): 656-663.
[3]	刘勖诚, 谷波, 曾炜杰, 杜仲星, 田镇. 小通道内制冷剂两相流动摩擦压降关联式分析[J]. 上海交通大学学报, 2021, 55(9): 1095-1107.
[4]	李岩松, 丁鼎倩, 韩东, 刘静, 梁永图. 起伏输油管道临界完全携积水油速数值模拟[J]. 上海交通大学学报, 2021, 55(7): 878-890.
[5]	李煜, 程广益, 李宗阳, 窦怡彬, 蒋君庭. 固体火箭发动机喷管两相流动下的热固耦合研究[J]. 空天防御, 2020, 3(1): 1-9.
[6]	谢行，任慧龙，陶凯东，冯亿坤. 应用改进流体体积法的楔形体斜向入水研究[J]. 上海交通大学学报, 2020, 54(1): 20-27.
[7]	王雨风，王丹东，胡记超，陈亮，陈江平. 两相流CO2喷射器内部流场的数值模型[J]. 上海交通大学学报, 2019, 53(7): 860-865.
[8]	邹良旭，马非，孟昭男，张鹏. 基于群体平衡模型的冰浆流动与传热特性数值研究[J]. 上海交通大学学报, 2019, 53(12): 1459-1465.
[9]	唐宜家, 马天寿, 何玉发, 陈平. 深水井筒两相流温度分布计算方法研究[J]. 海洋工程装备与技术, 2018, 5(增刊): 204-208.
[10]	邹旭毛，李良星，孔刘波，王华胜. 颗粒堆积床内两相流动阻力及相间摩擦力[J]. 上海交通大学学报（自然版）, 2017, 51(4): 470-.
[11]	刘勇1，陈炉云2. 涡激振动对管道液固两相流流场的影响[J]. 上海交通大学学报（自然版）, 2017, 51(4): 485-.
[12]	吴维武, 王东宝, 赵黎明, 袁振钦. 印刷电路板式LNG气化器换热试验研究[J]. 海洋工程装备与技术, 2016, 3(1): 20-24.
[13]	梅登飞，范浩杰，田凤国，崔璇，章明川. 黏性与非黏性颗粒在流化床中的气泡行为模拟[J]. 上海交通大学学报（自然版）, 2015, 49(05): 577-582.
[14]	李文升, 郭烈锦, 李乃良, 程兵, 姚海元. 集输-S型立管中空气-油两相流流型特征实验研究[J]. 海洋工程装备与技术, 2014, 1(1): 30-34.
[15]	王小川a,b，贺国a,c，郭朝有b，李雁飞b. 旋流强度对气/雾两相传热传质的影响[J]. 上海交通大学学报（自然版）, 2013, 47(11): 1767-1772.