| [1] Guan Rui, Gao Yong-jun. Brief analysis on fabrication process of AP1000 reactor coolant pump can [J].China Nuclear Power, 2008, 1(1): 49-53 (in Chinese).[2] Feng Ying-Hui. Mechanical analyses of the cans in AP1000 reactor coolant pump [D]. Shanghai: School of Nuclear Science and Engineering, Shanghai Jiaotong University, 2011 (in Chinese).[3] Liu H H, Jiang W, Hao M. New method used in assembly the stator component and its limit fluid pressure determination [J]. Nuclear Engineering and Design, 2012, 256: 256-263.[4] Hu Xue-fa, Zhao Zhen, Wang Fu-li, et al. Modeling and simulating of hydraulic tube tester’s main hydraulic system [J]. Journal of System Simulation, 2010, 20(18): 4994-4997 (in Chinese).[5] Han Xin-yu, Deng Xiu-jian, Liu Li. Modeling, simulation and analysis of the tube high-pressure hydroforming system [J]. Computer Simulation, 2010, 27(1): 292-295 (in Chinese).[6] Sun Hong-ze, Li Wei-min, Guo Yong-liang, et al. Research on key technology for thin-walled steel tube bulging hydraulic press [J]. Journal of Liaoning University of Technology: Natural Science Edition, 2009, 29(1): 42-47 (in Chinese).[7] Yuan An-ying, Wang Zhong-tang, Cheng Ming, et al. The establishment and problems discussion about the tube hydroforming system [J]. China Metal Forming Equipment & Manufacturing Technology, 2008(1): 80-84 (in Chinese).[8] Chai B M, Gao W J. Simulation on fuel injection system for EUP based on AMEsim [C]//Proceedings of 2010 Second International Conference on Computer Modeling and Simulation. Piscataway, NJ: IEEE, 2010: 456-458.[9] Zhang Z M, Zhou H. Proportional pressure control of water hydraulic system for water-assisted injection molding: Modeling and simulation [C]//Proceedings of 2008 ASME Dynamic Systems and Control Conference. Michigan, USA: ASME, 2008: 1-8.[10] Zhou H, Chen Y L, Zhang Z M, et al. Simulation and experiment research on the proportional pressure control of water-assisted injection molding [J]. Chinese Journal of Mechanical Engineering, 2012, 25(3): 430-438.[11] Zhou H, Zhang Z M, Gao Y A, et al. Water-assisted injection molding system based on oil hydraulic proportional control technique [J]. Chinese Journal of Mechanical Engineering, 2010, 23(4): 418-427. |
