湿工况下翅片管换热器空气侧热质传递的数值模型

上海交通大学学报（自然版） ›› 2013, Vol. 47 ›› Issue (03): 385-391.

湿工况下翅片管换热器空气侧热质传递的数值模型

韩维哲，丁国良，胡海涛，庄大伟

(上海交通大学机械与动力工程学院, 上海 200240)

收稿日期:2012-04-14 出版日期:2013-03-28 发布日期:2013-03-28

Numerical Model of Heat and Mass Transfer for Tube-Finned Heat Exchangers under Dehumidifying Conditions

HAN Wei-Zhe, DING Guo-Liang, HU Hai-Tao, ZHUANG Da-Wei

(School of Mechanical Engineering, Shanghai Jiaotong University, Shanghai 200240, China)

Received:2012-04-14 Online:2013-03-28 Published:2013-03-28

摘要/Abstract

摘要： 析湿在翅片管换热器用作蒸发器时经常发生，对换热器的性能有重要影响.文中提出了能从机理上对湿工况下翅片管式换热器空气侧的热质传递过程进行模拟的数值模型，它不仅包括用于反映水蒸气和液态水之间由于浓度差所形成的传质模型，而且包括基于经典成核理论的反映水蒸气直接冷凝过程的传质模型.该模型的计算精度较好，传热无量纲参数jh和实验数据的平均相对误差为6.93%，传质无量纲参数jm和实验数据的平均相对误差为12.1%.数值仿真表明，空气相对湿度仅在部分析湿工况下对传质特性有较大影响.

关键词: 析湿, 热质传递, 数值模型

Abstract: Dehumidifying process is very common in the evaporating conditions of finned tube heat exchangers, which has tremendous effect on the performance of heat exchangers. In order to make the simulation closer to the heat and mass transfer mechanisms, a numerical model of heat and mass transfer on air side was established. Not only is the mass transfer produced by the concentration difference between water vapor and liquid considered in this model but also the simulation of direct water vapor condensation is added by means of classical nucleation theory. The comparison between the numerical model and experimental data shows that the numerical model has good accuracy. The relative errors for jh factor and jm factor are 6.93% and 12.1% respectively. The numerical simulation shows that the relative humidity only affects the mass transfer characteristics under partial wet conditions.

Key words: dehumidifying, heat and mass transfer, numerical model

中图分类号:

TK 124

韩维哲, 丁国良, 胡海涛, 庄大伟. 湿工况下翅片管换热器空气侧热质传递的数值模型 [J]. 上海交通大学学报（自然版）, 2013, 47(03): 385-391.

HAN Wei-Zhe, DING Guo-Liang, HU Hai-Tao, ZHUANG Da-Wei. Numerical Model of Heat and Mass Transfer for Tube-Finned Heat Exchangers under Dehumidifying Conditions [J]. Journal of Shanghai Jiaotong University, 2013, 47(03): 385-391.

参考文献

［1］Manglik R M, Zhang J, Muley A. Low Reynolds number forced convection in three dimensional wavyplatefin compact
channels: Fin density effects ［J］. International Journal of Heat and Mass Transfer, 2005, 48: 14391449.
［2］Wang C C, Lin Y T, Lee C J. An airside correlation for plain finandtube heat exchangers in wet conditions ［J］.
International Journal of Heat and Mass Transfer, 2000, 43: 18691872.
［3］Wang C C, Lee W S, Sheu W J, et al. A comparison of the airside performance of the finandtube heat exchangers in
wet conditions: With and without hydrophilic coating ［J］. Applied Thermal Engineering, 2002, 22: 267278.
［4］Comini G, Croce G. Convective heat transfer and mass transfer in tubefinexchangers under dehumidifying
conditions ［J］. Numerical Heat Transfer, Part A, 2001, 40: 579599.
［5］Comini G, Nonino C, Savino S. Convective heat and mass transfer in wavy finnedtube exchangers ［J］. International
Journal of Numerical Methods for Heat & Fluid Flow, 2002, 12(6): 735755.
［6］Comini G, Nonino C, Savino S. Numerical evaluation of fin performance under dehumidifying conditions ［J］. Journal
of Heat transfer, 2007, 129: 13951402.
［7］Yang B, Sekhar S C. Numerical algorithm study of CFD modeling for a compartmented cooling coil under dehumidifying
conditions ［J］. Numerical Heat Transfer, Part A, 2007, 52: 737755.
［8］Viisanen Y, Strey R, Reiss H. Homogeneous nucleation rates for water ［J］. Journal of Chemical Physics, 1993, 99
(6): 46804692.
［9］Yang M, Dai H L. Heterogeneous nucleation and wetting of water thin films on a metal surface: A study by optical
second harmonic generation ［J］. Journal of Chemical Physics, 2003, 118(11): 51065114.
［10］Pirpmpugd W, Wongwises S, Wang C C. A tubebytube reduction method for simultaneous heat and mass transfer
characteristics for plain finandtube heat exchangers in dehumidifying conditions ［J］. Heat Mass Transfer, 2005, 41:
756765.
［11］Pirpmpugd W, Wang C C, Wongwises S. Finite circular fin method for heat and mass transfer characteristics for plain
finandtube heat exchangers under fully and partially wet surface conditions ［J］. International Journal of Heat and
Mass Transfer, 2007, 50: 552565.
［12］Pirpmpugd W, Wang C C, Wongwises S. A fully wet and fully dry tiny circular fin method for heat and mass transfer
characteristics for plain finandtube heat exchangers under dehumidifying conditions ［J］. Journal of Heat Transfer,
2007, 129: 12561267.
［13］Pirpmpugd W, Wang C C, Wongwises S. Heat and mass transfer characteristics for finned tube heat exchangers with
humidification ［J］. Journal of Thermophysics and Heat Transfer, 2007, 21(2): 361371.

[1]	王沙沙, 张翔宇, 邱国志, 龚景海. 一种分析膜面在积水荷载作用下响应的数值模型[J]. 上海交通大学学报, 2022, 56(6): 730-738.
[2]	潘佳禾，廖晨聪，陈锦剑. 孤立波作用下埋管斜坡海床及海底管道的响应分析[J]. 上海交通大学学报, 2019, 53(8): 898-906.
[3]	王宾, 李红涛, 唐广银. 海上浮式风机研究进展概述[J]. 海洋工程装备与技术, 2018, 5(增刊): 220-225.
[4]	马磊，谷波，田镇，李萍. 基于新流动沸腾传热关联式的微通道平行流蒸发器数值模型[J]. 上海交通大学学报（自然版）, 2017, 51(9): 1043-1049.
[5]	仲健林1，马大为1，任杰1，李士军2，王旭3. 基于平面应变假设的橡胶圆筒静态受压分析[J]. 上海交通大学学报（自然版）, 2015, 49(09): 1276-1280.
[6]	吕子洲1，李世阳2a，董彧1，毛向阳1，张延松2b，李书龙3. 汽车油位传感器磨损模型及磨损寿命的可靠性预测[J]. 上海交通大学学报（自然版）, 2014, 48(1): 69-73.