R410a制冷剂性能参数的显式快速计算模型
Ⅱ. 过 热 区 方 程

上海交通大学学报（自然版） ›› 2011, Vol. 45 ›› Issue (09): 1379-1383.

R410a制冷剂性能参数的显式快速计算模型
Ⅱ. 过热区方程

洪迎春，谷波，韩华

（上海交通大学制冷与低温工程研究所，上海 200240）

收稿日期:2010-03-20 出版日期:2011-09-30 发布日期:2011-09-30
基金资助:
国家自然科学基金项目（50876059）

Fast Calculation Model of Thermodynamic and Transport Properties of R410a Refrigerant：Ⅱ. Equation for Superheat Region

HONG Ying-Chun, GU Bo, HAN Hua

(Institute of Refrigeration and Cryogenics Engineering, Shanghai Jiaotong University, Shanghai 200240, China)

Received:2010-03-20 Online:2011-09-30 Published:2011-09-30

摘要/Abstract

摘要： 在Martin-Hou方程的基础上，提出了R410a制冷剂在过热区（压力4~4 355 kPa，过热度0~100 K）的热力学性能参数和传输特性参数的计算模型，以REFPROP 7的数据源作为原始数据，在过热区范围内对R410a制冷剂的热力学性能参数进行拟合，并将该模型的计算结果与REFPROP 7数据源进行对比.结果表明，所提出的显式计算模型的平均误差小于1.24%，最大误差小于14.30%，计算速度比REFPROP 7提高了2~4个数量级.

关键词: , R410a制冷剂, 热力学性能, 传输特性, 过热区, 计算模型, , R410a制冷剂, 热力学性能, 传输特性, 过热区, 计算模型

Abstract: Based on the Martin-Hou equation of state, a fast calculation model for R410a thermodynamic and transport properties, covering superheat region(pressure:4—4 355 kPa, superheating of 0—100 K), was presented due to no need of iteration. This method can not only achieve the accuracy, but guarantee the calculation stability and high calculation speed of thermophysical and transport properties of R410a, and it is also convenient in cases of simulation of refrigeration system. The source data was calculated from REFPROP 7. The total mean relative error and maximum relative error for all fast calculation models are less than 1.24% and 14.30%, respectively. The comparison result shows that the calculation speed of the fast calculation model is two to four orders faster than those of REFPROP 7.

Key words: R410 a refrigerant, thermodynamic properties, transport properties, superheat region, calculation model, R410 a refrigerant, thermodynamic properties, transport properties, superheat region, calculation model

中图分类号:

TB66

洪迎春, 谷波, 韩华. R410a制冷剂性能参数的显式快速计算模型
Ⅱ. 过热区方程[J]. 上海交通大学学报（自然版）, 2011, 45(09): 1379-1383.

HONG Ying-Chun, GU Bo, HAN Hua. Fast Calculation Model of Thermodynamic and Transport Properties of R410a Refrigerant：Ⅱ. Equation for Superheat Region[J]. Journal of Shanghai Jiaotong University, 2011, 45(09): 1379-1383.

参考文献

［1］Monte F D. Calculation of thermodynamic properties of R407c and R410a by the MartinHou equation of state:Part I.Theoretical development［J］. Int J Refrig, 2002, 25 (3): 306313.

［2］Monte F D. Calculation of thermodynamic properties of R407c and R410a by the MartinHou equation of state:Part II.Technical interpretation［J］. Int J Refrig, 2002, 25 (3): 314329.

［3］McLinden M O, Klein S A. Lemmon E W NIST REFPROP V7.0［M］. USA: National Institute of Standards and Technology, 2006.

［4］DuPont Fluorochemicals. Thermodynamic properties of Suva 9100 refrigerant ［R］. DuPont Technical Information R410A (50/50). Wilmington, DE, USA:DuPont Company, 1996.

［5］Cleland A C. Polynomial curvefits for refrigerant thermodynamic properties: Extension to include R134a［J］. Int J Refrig, 1994, 17 (4):121123.

［6］Cleland A C. Computer subroutines for rapid evaluation of refrigerant thermodynamic: Properties［J］. Int J Refrig, 1986, 9 (8): 346351.

［7］MartinDominguez I R, McDonald T W. Correlation for some saturated thermodynamic and transport properties of refrigerant R22［J］. ASHRAE Trans, 1993, 99 (1): 344348.

［8］胡欢，谷波，龙琼, 等. 亚临界压力区CO2热力性质及传输特性的快速计算模型［J］. 上海交通大学学报，2008，42（8）:12601263.

HU Huan, GU Bo, LONG Qiong, et al. Fast calculation model of thermodynamic and transport properties of CO2 in subcritical pressure region［J］. Journal of Shanghai Jiaotong University, 2008, 42(8):12601263.

［9］龙琼，谷波.过热区R22热力性质及传输特性的快速计算模型［J］.流体机械，2009 (2): 6972.

LONG Qiong, GU Bo. Fast calculation model of thermodynamic and transport properties of R22 in superheat region［J］. Fluid Machinery, 2009 (2):6972.

［10］洪迎春，谷波，韩华. R410a制冷剂性能参数的显式快速计算模型:Ⅰ. 饱和线方程［J］. 上海交通大学学报，2011,45（9）：13741378.

HONG Yingchun, GU Bo, HAN Hua. Fast calculation model of thermodynamic and transport properties of R410a:Ⅰ. Equation for saturation curve［J］. Journal of Shanghai Jiaotong University, 2011,45（9）：13741378.

[1]	王聚团, 戚晓宁, 黄志明. 水下生产管汇测试技术及其改进研究[J]. 海洋工程装备与技术, 2022, 9(2): 43-49.
[2]	袁振钦, 邹科, 孙亚峰, 刘刚, 屈衍, 李居跃. 基于时域分析法的动态电缆疲劳分析[J]. 海洋工程装备与技术, 2022, 9(2): 50-55.
[3]	王娟, 杨明旺, 郑茂尧, 刘凌云, 赵立君. 高强钢在大型半潜式平台组块建造中的应用[J]. 海洋工程装备与技术, 2022, 9(1): 27-31.
[4]	陈欣, 赵晓磊, 王立坤, 肖德明, 张腾月. 深水大型吸力锚建造技术研究[J]. 海洋工程装备与技术, 2022, 9(1): 32-36.
[5]	尹彦坤, 易涤非. 半潜式生产平台船体结构关键节点工程临界评估[J]. 海洋工程装备与技术, 2022, 9(1): 52-57.
[6]	MA Qunsheng (马群圣), CEN Xingxing (岑星星), YUAN Junyi (袁骏毅), HOU Xumin (侯旭敏). Word Embedding Bootstrapped Deep Active Learning Method to Information Extraction on Chinese Electronic Medical Record[J]. J Shanghai Jiaotong Univ Sci, 2021, 26(4): 494-502.
[7]	ZHANG Shengfa (张胜发), TANG Na (唐纳), SHEN Guofeng (沈国峰), WANG Han (王悍), QIAO Shan (乔杉). Universal Software Architecture of Magnetic Resonance-Guided Focused Ultrasound Surgery System and Experimental Study[J]. J Shanghai Jiaotong Univ Sci, 2021, 26(4): 471-481.
[8]	安庆升, 孙立东, 武秋生. 碳纤维增强复合材料发射筒设计研究[J]. 空天防御, 2021, 4(2): 13-.
[9]	KONG Xiangqiang (孔祥强), MENG Xiangxi (孟祥熙), LI Jianbo (李见波), SHANG Yanping (尚燕平), CUI Fulin (崔福林) . Comparative Study on Two-Stage Absorption Refrigeration Systems with Different Working Pairs[J]. J Shanghai Jiaotong Univ Sci, 2021, 26(2): 155-162.
[10]	ZHUANG Weimin (庄蔚敏), WANG Pengyue (王鹏跃), AO Wenhong (熬文宏), CHEN Gang (陈刚) . Experiment and Simulation of Impact Response of Woven CFRP Laminates with Different Stacking Angles[J]. J Shanghai Jiaotong Univ Sci, 2021, 26(2): 218-230.
[11]	ZHOU Xuhui (周旭辉), ZHANG Wenguang (张文光), XIE Jie (谢颉). Effects of Micro-Milling and Laser Engraving on Processing Quality and Implantation Mechanics of PEG-Dexamethasone Coated Neural Probe[J]. J Shanghai Jiaotong Univ Sci, 2021, 26(1): 1-9.
[12]	HUANG Ningning (黄宁宁), MA Yixin (马艺馨), ZHANG Mingzhu (张明珠), GE Hao (葛浩), WU Huawei (吴华伟). Finite Element Modeling of Human Thorax Based on MRI Images for EIT Image Reconstruction[J]. J Shanghai Jiaotong Univ Sci, 2021, 26(1): 33-39.
[13]	WANG Xianjin, GAO Xu, YU Kuigang . Fixture Locating Modelling and Optimization Research of Aluminum Alloy Sidewall in a High-Speed Train Body[J]. J Shanghai Jiaotong Univ Sci, 2020, 25(6): 706-713.
[14]	QIAO Xing, MA Dan, YAO Xuliang, FENG Baolin. Stability and Numerical Analysis of a Standby System[J]. J Shanghai Jiaotong Univ Sci, 2020, 25(6): 769-778.
[15]	WU Jin, MIN Yu, YANG Xiaodie, MA Simin . Micro-Expression Recognition Algorithm Based on Information Entropy Feature[J]. Journal of Shanghai Jiao Tong University(Science), 2020, 25(5): 589-599.