The purpose of this research is to explore the feasibility of roller hemming of AZ31B magnesium alloy sheet. During the test, a special experimental setup considering the current flow and insulation was designed and employed. For the sake of simplicity, the flat surface-straight edge hemming style was selected. Electrical pulses were introduced in the pre-hemming and final hemming processes. The results show that when hemming at 448 K with hemming speed of 30 mm/min, AZ31B magnesium alloy sheet was successfully hemmed with excellent perceived quality. No recoil/warp defect, cracking or springback was observed. Electrical pulses induced dynamic recrystallized grains were observed along the grain boundaries in the severely deformed area, which is of great importance to the improvement of the ductility of the material. The hardness was slightly increased after hemming with electrical pulses, and this fact could improve the friction resistance performance of the hemmed part. © 2016, Shanghai Jiaotong University and Springer-Verlag Berlin Heidelberg.