Abstract: Oil-based nanofluids including 0.75%—1.75% (mass fraction) carbon nanotubes (CNTs) without any surfactants have been synthesized by a two-step process. The probes machined from 45# steel with 22mm diameter and 50mm length are quenched in the as-synthesized CNT nanofluids for testing the cooling behaviors of the nanofluids. The laser diffraction particle size analyzer, scanning electronic microscope (SEM), X-ray diffractometer and transmission electron microscope (TEM) are used to characterize the quality and distribution of CNTs in the nanofluids. The wettability and viscosity of 30# oil and oil-based CNT nanofluids are measured by a goniometer at 15 °C and a rotational type viscometer at 40 °C, respectively. The results show that the cooling efficiency of the oil-based CNT nanofluids is better than that of 30# oil. Moreover, the cooling rate of the naonofluids increases with the further increase of the CNT concentration. When the mass fraction of CNTs increases to 1.75%, the cooling rate of the naonofluids reaches a maximum at 760 °C and it is increased by 77.8% as compared to that of base oil. The improved cooling rate of oil by CNTs is mainly due to the uniform distribution and excellent thermal conductivity of CNTs.
CHEN Si* (陈斯), ZENG Xiaoshu (曾效舒), YUAN Qiuhong (袁秋红)
. Effect of Carbon Nanotube Concentration on Cooling Behaviors of Oil-Based Nanofluids During the Immersion Quenching[J]. Journal of Shanghai Jiaotong University(Science), 2017
, 22(4)
: 395
-401
.
DOI: 10.1007/s12204-017-1852-2
[1] EASTMAN J A, PHILLPOT S R, CHOI S U S, et al.Thermal transport in nanofluids [J]. Annual Review of Materials Research, 2004, 34(1): 219-246. [2] KAKAC S, PRAMUANJAROENKIJ A. Review of convective heat transfer enhancement with nanofluids[J]. International Journal of Heat and Mass Transfer,2009, 52(13/14): 3187-3196. [3] FAN L W, LI J Q, LI D Y, et al. The effect of concentration on transient pool boiling heat transfer of graphene-based aqueous nanofluids [J]. International Journal of Thermal Sciences, 2015, 91: 83-95. [4] HAGHIGHI E B, UTOMO A T, GHANBRAPOURM,et al. Combined effect of physical properties and convective heat transfer coefficient of nanofluids on their cooling efficiency [J]. International Communications in Heat and Mass Transfer, 2015, 68: 32-42. [5] WANG X Q, MUJUMDAR A S. Heat transfer characteristics of nanofluids: A review [J]. International Journal of Thermal Sciences, 2007, 46(1): 1-19. [6] DUURSMA G, SEFIANE K, KENNEDY A. Experimental studies of nanofluid droplets in spray cooling[J]. Heat Transfer Engineering, 2009, 30(13): 1108-1120. [7] IIJIMA S. Helical microtubules of graphitic carbon [J].Nature, 1991, 354(6348): 56-58. [8] CHOI S U S. Nanofluids: From vision to reality through research [J]. Journal of Heat Transfer, 2009,131(3): 189-203. [9] PARK K J, JUNG D. Enhancement of nucleate boiling heat transfer using carbon nanotubes [J]. International Journal of Heat and Mass Transfer, 2007, 50(21/22):4499-4502. [10] DING Y, ALIAS H, WEN D, et al. Heat transfer of aqueous suspensions of carbon nanotubes (CNT nanofluids) [J]. International Journal of Heat and Mass Transfer, 2006, 49(1/2): 240-250. [11] XIE H, LEE H, YOUN W, et al. Nanofluids containing multiwalled carbon nanotubes and their enhanced thermal conductivities [J]. Journal of Applied Physics,2003, 94(8): 4967-4971. [12] KEBLINSKI P, PHILLPOT S R, CHOI S U S, et al.Mechanisms of heat flow in suspensions of nano-sized particles (nanofluids) [J]. International Journal of Heat and Mass Transfer, 2002, 45(4): 855-863. [13] DAS S K, PUTRA N, THIESEN P, et al. Temperature dependence of thermal conductivity enhancement for nanofluids [J]. Journal of Heat Transfer, 2003, 125(4):567-574. [14] CHOPKAR M, SUDARSHAN S, DAS P K, et al.Effect of particle size on thermal conductivity of nanofluid [J]. Metallurgical and Materials Transactions A, 2008, 39(7): 1535-1542. [15] LIU M S, LIN M C C, HUANG I T, et al. Enhancement of thermal conductivity with carbon nanotube for nanofluids [J]. International Communications in Heat and Mass Transfer, 2005, 32: 1202-1210. [16] AMROLLAHI A, HAMIDI A A, RASHIDI A M. The effects of temperature, volume fraction and vibration time on the thermo-physical properties of a carbon nanotube suspension (carbon nanofluid) [J]. Nanotechnology,2008, 19(31): 315701. [17] CHEN L F, XIE H Q, LI Y, et al. Nanofluids containing carbon nanotubes treated by mechanochemical reaction [J]. Thermochimica Acta, 2008, 477(1/2):21-24. [18] GARG P, ALVARADO J L, MARSH C, et al. An experimental study on the effect of ultrasonication on viscosity and heat transfer performance of multi-wall carbon nanotube-based aqueous nanofluids [J]. International Journal of Heat and Mass Transfer, 2009,52(21/22): 5090-5101. [19] KIM M, CHANG K H. Measurement of the dispersion stability of pristine and surface-modified multiwalled carbon nanotubes in various nonpolar and polar solvents[J]. Measurement Science and Technology, 2007,18(12): 3707-3712. [20] PRABHU K N, FERNADES P. Nanoquenchants for industrial heat treatment [J]. Journal of Materials Engineering and Performance, 2008, 17(1): 101-103. [21] CHOPKAR M, KUMAR S, BHANDARI D R, et al.Development and characterization of Al2Cu and Ag2Al nanoparticle dispersed water and ethylene glycol based nanofluid [J]. Materials Science and Engineering B,2007, 139(2/3): 141-148. [22] ARONOV M. Practical application of intensive quenching process for steel parts [C]//The ASM Heat Treating Society Conference. [s.l.]: ASM, 2000: 778-784. [23] FREBORG A M, FERGUSON B L, ARONOV M A,et al. Intensive quenching theory and application for imparting high residual surface compressive stresses in pressure vessel components [C]//ASME 2002 Pressure Vessels and Piping Conference. [s.l.]: ASME, 2002: 32-43.
