A hydraulic experimental platform for the assembly of stator components was developed, and the
simulation on this system was performed based on software AMEsim. Characteristics of the system, such as the
pressure and the displacement, were analyzed. The results guide design of the hydraulic system of experiment
platform for the assembly of the stator.
HAO Ming (郝 明), JIANG Wei* (蒋 玮)
. AMEsim Based Simulation on Hydraulic Experiment Rig for Assembly of Stator Components[J]. Journal of Shanghai Jiaotong University(Science), 2013
, 18(5)
: 570
-576
.
DOI: 10.1007/s12204-013-1429-7
[1] Guan Rui, Gao Yong-jun. Brief analysis on fabrication process of AP1000 reactor coolant pump can [J].China Nuclear Power, 2008, 1(1): 49-53 (in Chinese).
[2] Feng Ying-Hui. Mechanical analyses of the cans in AP1000 reactor coolant pump [D]. Shanghai: School of Nuclear Science and Engineering, Shanghai Jiaotong University, 2011 (in Chinese).
[3] Liu H H, Jiang W, Hao M. New method used in assembly the stator component and its limit fluid pressure determination [J]. Nuclear Engineering and Design, 2012, 256: 256-263.
[4] Hu Xue-fa, Zhao Zhen, Wang Fu-li, et al. Modeling and simulating of hydraulic tube tester’s main hydraulic system [J]. Journal of System Simulation, 2010, 20(18): 4994-4997 (in Chinese).
[5] Han Xin-yu, Deng Xiu-jian, Liu Li. Modeling, simulation and analysis of the tube high-pressure hydroforming system [J]. Computer Simulation, 2010, 27(1): 292-295 (in Chinese).
[6] Sun Hong-ze, Li Wei-min, Guo Yong-liang, et al. Research on key technology for thin-walled steel tube bulging hydraulic press [J]. Journal of Liaoning University of Technology: Natural Science Edition, 2009, 29(1): 42-47 (in Chinese).
[7] Yuan An-ying, Wang Zhong-tang, Cheng Ming, et al. The establishment and problems discussion about the tube hydroforming system [J]. China Metal Forming Equipment & Manufacturing Technology, 2008(1): 80-84 (in Chinese).
[8] Chai B M, Gao W J. Simulation on fuel injection system for EUP based on AMEsim [C]//Proceedings of 2010 Second International Conference on Computer Modeling and Simulation. Piscataway, NJ: IEEE, 2010: 456-458.
[9] Zhang Z M, Zhou H. Proportional pressure control of water hydraulic system for water-assisted injection molding: Modeling and simulation [C]//Proceedings of 2008 ASME Dynamic Systems and Control Conference. Michigan, USA: ASME, 2008: 1-8.
[10] Zhou H, Chen Y L, Zhang Z M, et al. Simulation and experiment research on the proportional pressure control of water-assisted injection molding [J]. Chinese Journal of Mechanical Engineering, 2012, 25(3): 430-438.
[11] Zhou H, Zhang Z M, Gao Y A, et al. Water-assisted injection molding system based on oil hydraulic proportional control technique [J]. Chinese Journal of Mechanical Engineering, 2010, 23(4): 418-427.
