Improvement of Oil/Water Selectivity by Stearic Acid Modified Expanded Perlite for Oil Spill Cleanup

doi:10.1007/s12204-013-1426-x

Abstract

Abstract: Ecological disasters and economic losses resulting from oil spills have reminded us the necessity for finding an environmentally friendly, cost-effective, and available in large-scale materials to minimize the oil spill effects. The development of high oil/water selectivity mineral sorbent for the removal of oil from the water is of great interest for oil spill cleanup. In this work, highly oil/water selectivity sorbent of expanded perlite modified with stearic acid was prepared by solution-immersion processes, and the characterization of sorbent was analyzed by Fourier transformation infrared (FT-IR) spectroscopy technique. The optimized amount of loaded stearic acid (SA) on the expanded perlite surface was found to be 2.0%. Then the sorption characteristics of unmodified expanded perlite (UMEP) and stearic acid modified expanded perlite (SMEP) were tested. The effects of different particles size, oil/water volume ratio and sorption simulated condition were investigated. It was found that expanded perlite modified with stearic acid could adsorb selectively oil from water in oil/water system. The maximum oil/water sorption ratio of SMEP was 46, which was about 191 times that of UMEP (0.24) in studied experimental range. The FT-IR analysis demonstrated the presence of long-chain alkyl group in the SMEP samples, which played an important role in oil/water selectivity of SMEP samples. The equilibrium were tested with Langmuir and Freundlich isotherm models, and oil sorption process of SMEP showed good correlation with the Langmuir isotherm model.

Key words: expanded perlite| stearic acid| oil spill| sorption| selectivity

摘要： Ecological disasters and economic losses resulting from oil spills have reminded us the necessity for finding an environmentally friendly, cost-effective, and available in large-scale materials to minimize the oil spill effects. The development of high oil/water selectivity mineral sorbent for the removal of oil from the water is of great interest for oil spill cleanup. In this work, highly oil/water selectivity sorbent of expanded perlite modified with stearic acid was prepared by solution-immersion processes, and the characterization of sorbent was analyzed by Fourier transformation infrared (FT-IR) spectroscopy technique. The optimized amount of loaded stearic acid (SA) on the expanded perlite surface was found to be 2.0%. Then the sorption characteristics of unmodified expanded perlite (UMEP) and stearic acid modified expanded perlite (SMEP) were tested. The effects of different particles size, oil/water volume ratio and sorption simulated condition were investigated. It was found that expanded perlite modified with stearic acid could adsorb selectively oil from water in oil/water system. The maximum oil/water sorption ratio of SMEP was 46, which was about 191 times that of UMEP (0.24) in studied experimental range. The FT-IR analysis demonstrated the presence of long-chain alkyl group in the SMEP samples, which played an important role in oil/water selectivity of SMEP samples. The equilibrium were tested with Langmuir and Freundlich isotherm models, and oil sorption process of SMEP showed good correlation with the Langmuir isotherm model.

关键词: expanded perlite| stearic acid| oil spill| sorption| selectivity

CLC Number:

X 522

QI Pei-shi* (祁佩时), LIN Na (林娜), LIU Yun-zhi (刘云芝), ZHAO Jun-jie (赵俊杰). Improvement of Oil/Water Selectivity by Stearic Acid Modified Expanded Perlite for Oil Spill Cleanup[J]. Journal of shanghai Jiaotong University (Science), 2013, 18(4): 500-507.

References

[1] Abdullah M A, Rahmah A U, Man Z. Physicochemical and sorption characteristics of Malaysian Ceiba pentandra (L.) Gaertn. as a natural oil sorbent [J]. Journal of Hazardous Materials, 2010, 177(1-3): 683-691.
[2] Lin Q X, Mendelssohn I A. Impacts and recovery of the deepwater horizon oil spill on vegetation structure and function of coastal salt marshes in the northern Gulf of Mexico [J]. Environmental Science & Technology,2012, 46(7): 3737-3743.
[3] Amini A, Bollaert E, Boillat J L, et al. Dynamics of low-viscosity oils retained by rigid and flexible barriers [J]. Ocean Engineering, 2008, 35(14-15): 1479-1491.
[4] Lin J Y, Shang Y W, Ding B, et al. Nanoporous polystyrene fibers for oil spill cleanup [J]. Marine Pollution Bulletin, 2012, 64(2): 347-352.
[5] Kujawinski E B, Kido Soule M C, Valentine D L, et al. Fate of dispersants associated with the deepwater horizon oil spill [J]. Environmental Science & Technology, 2011, 45(4): 1298-1306.
[6] Fritt-Rasmussen J, Brandvik P J, Villumsen A,et al. Comparing ignitability for in situ burning of oil spills for an asphaltenic, a waxy and a light crude oil as a function of weathering conditions under arctic conditions [J]. Cold Regions Science and Technology, 2012, 72: 1-6.
[7] Hosokawa R, Nagai M, Morikawa M, et al. Autochthonous bioaugmentation and its possible application to oil spills [J]. World Journal of Microbiology and Biotechnology, 2009, 25(9): 1519-1528.
[8] Karan C P, Rengasamy R S, Das D. Oil spill cleanup by structured fibre assembly [J]. Indian Journal of Fibre & Textile Research, 2011, 36(2): 190-200.
[9] Adebajo M O, Frost R L, Kloprogge J T, et al. Porous materials for oil spill cleanup: A review of synthesis and absorbing properties [J]. Journal of Porous Materials, 2003, 10(3): 159-170.
[10] Wei Q F, Mather R R, Fotheringham A F, et al. Evaluation of nonwoven polypropylene oil sorbents in marine oil-spill recovery [J]. Marine Pollution Bulletin, 2003, 46(16): 780-783.
[11] Duong H T T, Burford R P. Effect of foam density, oil viscosity, and temperature on oil sorption behavior of polyurethane [J]. Journal of Applied Polymer Science, 2006, 99(1): 360-367.
[12] Ali N, El-Harbawi M, Jabal A A, et al. Characteristics and oil sorption effectiveness of kapok fibre, sugarcane bagasse and rice husks: oil removal suitability matrix [J]. Environmental Technology, 2012, 33(4): 481-486.
[13] Alkan M, Karadas M, Doˇgn M, et al. Adsorption of CTAB onto perlite samples from aqueous solutions [J]. Journal of Colloid and Interface Science, 2005, 291(2): 309-318.
[14] Teas Ch, Kalligeros S, Zanikos F, et al. Investigation of the effectiveness of absorbent materials in oil spills clean up [J]. Desalinaion, 2001, 140(3): 259-264.
[15] Bastani D, Safekordi A A, Alihosseini A, et al. Study of oil sorption by expanded perlite at 298.15K [J]. Separation and Purification Technology, 2006, 52(2): 295-300.
[16] Carmody O, Frost R, Xi Y F, et al. Adsorption of hydrocarbons on organo-clays-Implications for oil spill remediation [J]. Journal of Colloid and Interface Science, 2007, 305(1): 17-24.
[17] Machado L C R, Lima F W J, Paniago R, et al. Polymer coated vermiculite-iron composites: Novel floatable magnetic adsorbents for water spilled contaminants [J]. Applied Clay Science, 2006, 31(3-4): 207-215.
[18] Zhao M Q, Huang J Q, Zhang Q, et al. Improvement of oil adsorption performance by a sponge-like natural vermiculite-carbon nanotube hybrid [J]. Applied Clay Science, 2011, 53(1): 1-7.
[19] ASTM D95-83, Standard test method for water in petroleum products and bituminous materials by distillation[S].
[20] Sodeyama K, Sakka Y, Kamino Y, et al. Preparation of fine expanded perlite [J]. Journal of Materials Science, 1999, 34(10): 2461-2468.
[21] Doˇgn M, Alkan M, Onganer Y. Adsorption of methylene blue from aqueous solution onto perlite [J]. Water, Air & Soil Pollution, 2000, 120(3-4): 229-248.
[22] Alkan M, Doˇgn M. Surface titrations of perlite suspensions [J]. Journal of Colloid and Interface Science, 1998, 207(1): 90-96.
[23] Roulia M, Chassapis K, Fotinopoulos C, et al. Dispersion and sorption of oil spills by emulsifiermodified expanded perlite [J]. Spill Science and Technology Bulletin, 2003, 8(5-6): 425-431.
[24] Langmuir I. The adsorption of gases on plane surfaces of glass, mica and platinum [J]. Journal of the American Chemical Society, 1918, 40(9): 1361-1403. [25] Freundlich H M F. ¨Uber die adsorption in l¨osungen [J]. Zeitschrift fur Physikalische Chemie, 1906, 57:385-470.
[26] Mckay G, Poots V J P. Kinetics and diffusion processes in colour removal from effluent using wood as an adsorbent [J]. Journal of Chemical Technology and Biotechnology, 1980, 30(1): 279-292.