This paper proposes a method of generating the roller path in multi-pass asymmetric spinning process for the hollow part with straight-edge round-corner cross-section. With the principle of volume invariance, the strain distribution of general hollow part with straight-edge round-corner cross-section is analyzed under the premise of plane strain condition in conventional spinning process. The point set for each pass is generated by rationally assigning the deformation of per pass. The non-axisymmetric spinning device with independent rotation between mandrel and wheel is used to process the hollow part with three straight-edge round-corner cross-section, and the thickness distribution and spring-back of the part are measured to verify the feasibility of this method. All of the results provide a new idea for digital non-axisymmetric spinning technology.
HUANG Yan，LU Bin，CHEN Jun
. A Parametric Toolpath Design in Muti-Pass Asymmetric Spinning[J]. Journal of Shanghai Jiaotong University, 2017
, 51(11)
: 1328
-1333
.
DOI: 10.16183/j.cnki.jsjtu.2017.11.007
［1］陈嘉, 万敏, 李卫东. 多道次普通旋压渐开线轨迹设计及其在数值模拟中的应用［J］. 塑性工程学报, 2008, 15(6): 53-57.
CHEN Jia, WAN Min, LI Weidong. Design of the involute trace of multi-pass conventional spinning and application in numerical simulation［J］. Journal of Plasticity Engineering, 2008, 15(6): 53-57.
［2］MUSIC O, ALLWOODA J M, KAWAIB K. A review of mechanics of metal spinning［J］. Journal of Materials Processing Technology, 2010, 210(1): 3-23.
［3］LIU J H, YANG H, LI Y Q. A study of the stress and strain distributions of first-pass conventional spinning under different roller-traces［J］. Journal of Materials Processing Technology, 2002, 129(1-3): 326-329.
［4］WANG L, LONG H,LI Y Q. A study of effects of roller path profiles on tool forces and part wall thickness variation in conventional metal spinning［J］. Journal of Materials Processing Technology, 2011, 211(12): 2140-2151.
［5］POLYBLANK J A, ALLWOOD J M. Parametric toolpath design in metal spinning［J］. Manufacturing Technology, 2015, 64(1): 301-304.
［6］赖周艺. 非圆横截面空心零件旋压成形机理研究［D］. 广州: 华南理工大学机械与汽车工程学院, 2012.
［7］WANG L, LONG H. Investigation of material deformation in multi-pass conventional metal spinning［J］. Materials & Design, 2011, 32(5): 2891-2899.
［8］HRTEL S, LAUE R. An optimization approach in non-circular spinning Sebastian［J］. Journal of Materials Processing Technology, 2016, 229: 417-430.
