The research tested the effect of fuel supply parameters on combustion and particle emission characteristics on a diesel engine fueled with neat diesel and blends of polyoxymethylene dimethyl ethers (PODE)/diesel (φPODE=20%). The results showed that the increase of common rail pressure could cause advanced main fuel heat release, higher peak incylinder pressure and higher mean gas temperature; the increased common rail pressure would decrease accumulation mode particle (AMP) emission, but would increase nucleation mode particle (NMP) emission under lightduty mode. The advanced pilot injection timing would lower the pilot fuel heat release, and improve the main injection heat release under low load; the advanced pilot injection timing would effectively reduce the AMP number concentration, but cause obvious NMP number increase. The advanced main injection timing directly shifted the main fuel heat release rate and caused an advanced, increased pressure peak; earlier main injection timing would cause lower AMP number concentration and higher NMP emission under lowduty mode, and obtained opposite results under highduty mode. The introduction of PODE could amplify the positive effect of fuel supply parameters on particle emissions and suppress the NMP emission to a certain extent.
LIN Da,ZHU Yijia,WEI Xiaodong,WANG Zhiyu,ZHANG Wugao
. Combustion and Particle Emission Characteristics Affected by
Fuel Supply Parameters for a Diesel Engine Fuelled with
Polyoxymethylene Dimethyl Ethers/Diesel[J]. Journal of Shanghai Jiaotong University, 2017
, 51(7)
: 787
-795
.
DOI: 10.16183/j.cnki.jsjtu.2017.07.004
［1］WANG J X, WU F J, XIAO J H, et al. Oxygenated blend design and its effects on reducing diesel particulate emissions［J］. Fuel, 2009, 88: 20372045.
［2］BURGER J, SIEGERT M, STROFER E, et al. Poly (oxymethylene) dimethyl ethers as components of tailored diesel fuel: Properties, synthesis and purification concepts［J］. Fuel, 2010, 89(11): 33153319.
［3］SONG J, CHENKKACHORN K, WANG J, et al. Effect of oxygenated fuel on combustion and emissions in a lightduty turbo diesel engine［J］. Energy & Fuels, 2002, 16(2): 294301.
［4］肖潇, 郑轶, 王云芳, 等. 聚甲氧基二甲醚 (PODE) 与柴油的互溶性研究［J］. 柴油机, 2015, 37(3): 2428.
XIAO Xiao, ZHENG Yi, WANG Yunfang , et al. Research on compatibility of PODE and diesel fuel［J］. Diesel Engine, 2015, 37(3): 2428.
［5］王志, 刘浩业, 张俊, 等. 聚甲氧基二甲醚与柴油混合燃料的燃烧与排放特性［J］. 汽车安全与节能学报, 2015, 6(2): 191197.
WANG Zhi, LIU Haoye, ZHANG Jun, et al. Combustion and emission characteristics of diesel engines fueled by polyoxymethylene dimethyl ethers (PODEn)［J］. Automotive Safety and Energy, 2015, 6(2): 191197.
［6］杨皓, 李兴虎, 牟鸣飞, 等. 柴油/聚甲氧基二甲醚混合燃料的柴油机性能与排放试验［J］. 汽车安全与节能学报, 2015, 6(3): 280285.
YANG Hao, LI Xinghu, MU Mingfei, et al. Experiments on the performances and emissions of diesel engine fueled with diesel/polyoxymethylene dimethyl ethers blends［J］. Automotive Safety and Energy, 2015, 6(3): 280285.
［7］PELLEGRINI L, MARCHIONNA M, PATRINI R, et al. Emission performance of neat and blended polyoxymethylene dimethyl ethers in an old lightduty diesel car ［EB/OL］. ［20161031］. https:∥saemobilus.sae.org/content/2013011035.
［8］PELLEGRINI L, MARCHIONNA M, PATRINI R, et al. Combustion behavior and emission performance of neat and blended polyoxymethylene dimethyl ethers in a lightduty diesel engine［EB/OL］. ［20161031］. https:∥saemobilus.sae.org/content/2012011053.
［9］张向京, 武朋涛, 蒋子超,等. 聚甲醛二甲醚反应热力学分析［J］. 化学工程, 2015, 43(4):3944.
ZHANG Xiangjing, WU Pengtao, JIANG Zichao, et al. Thermodynamic analysis on synthesis of polyoxymethylene dimethyl ethers［J］. Chemical Engineering, 2015, 43(4): 3944.
［10］张武高, 魏小栋, 林达, 等. 聚甲氧基二甲醚对发动机超细颗粒排放特性影响的试验研究［J］. 汽车安全与节能学报, 2016,7(3): 330336.
ZHANG Wugao, WEI Xiaodong, LIN Da, et al. Experimental study on the influence of polyoxymethylene dimethyl ethers (PODE) on ultrafine particle emission of a compression ignition engine［J］. Automotive Safety and Energy, 2016,7(3): 330336.
［11］HUSSEIN T. Indoor and outdoor aerosol particle size characterization in Helsinki［R］. Helsinki, Finland: University of Helsinki, 2005.
