[1]ECHARD B, GAYTON N, LEMAIRE M. AK-MCS: An active learning reliability method combining Kriging and Monte Carlo simulation[J]. Structural Safety, 2011, 33(2): 145-154.
[2]张崎. 基于Kriging方法的结构可靠性分析及优化设计[D].大连: 大连理工大学, 2005.
ZHANG Qi. Structure reliability analysis and optimization based on Kriging technique[D]. Dalian: Dalian University of Technology, 2005.
[3]RASHKI M, MIRI M, MOGHADDAM M A. A new efficient simulation method to approximate the probability of failure and most probable point[J]. Structural Safety, 2012, 39(4): 22-29.
[4]OKASHA N M . An improved weighted average si-mulation approach for solving reliability-based analysis and design optimization problems [J]. Structural Safety, 2016, 60: 47-55.
[5]ECHARD B, GAYTON N, LEMAIRE M, et al. A combined Importance Sampling and Kriging reliability method for small failure probabilities with time-demanding numerical models[J]. Reliability Engineering and System Safety, 2012, 111(2): 232-240.
[6]陆强华. 基于径向基函数神经网络的结构可靠性分析[J]. 中国科技信息, 2008(5): 234-235.
LU Qianghua. Structure reliability analysis based on radial basis function neural network[J]. China Science and Technology Information, 2008 (5): 234-235.
[7]康飞, 李俊杰, 李守巨, 等. 边坡系统可靠度分析智能响应面法框架[J]. 武汉大学学报(工学版), 2016, 49(5): 654-660.
KANG Fei, LI Junjie, LI Shouju, et al. Framework of intelligent response surface methods for system reliability analysis of slopes[J]. Engineering Journal of Wuhan University, 2016, 49(5): 654-660.
[8]徐元铭, 陈丽华, 彭兴林. 进化神经网络响应面法在结构可靠性中应用[J]. 飞机设计, 2008, 28(5): 33-38.
XU Yuanmin, CHEN Lihua, PENG Xinglin. Evolutionary neural network response surface for structural reliability analysis [J]. Aircraft Design, 2008, 28(5): 33-38.
[9]胡新明,王德禹. 基于迭代均值组合近似模型和序贯优化与可靠性评估法的船舶结构优化设计[J].上海交通大学学报, 2017, 51(2): 150-156.
HU Xinming, WANG Deyu. Optimization of ship structures using ensemble of surrogate with recursive arithmetic average and sequential optimization and reliability assessment[J]. Journal of Shanghai Jiao Tong University, 2017, 51(2): 150-156.
[10]周明光.基于径向基函数的结构可靠性分析算法研究[D].长沙: 湖南大学, 2013.
ZHOU Mingguang. Research on structural reliability analysis based on radial basis function[D]. Changsha: Hunan University, 2013.
[11]DNV. Structural reliability analysis of marine structures. Classification notes no. 30.6, Det Norske Veritas Classification, AS, Hovik[M]. Norway: DNV, 1992.
[12]常海超, 冯佰威, 刘祖源, 等. 船型优化中样本点选取方法对近似模型精度的影响研究[J]. 中国造船, 2013, 54(4): 84-93.
CHANG Haichao, FENG Baiwei, LIU Zuyuan, et al. Influence of sample points’ selection methods on the accuracy of approximation model in hull form optimization[J]. Shipbuilding of China, 2013, 54(4): 84-93.
[13]杨卓懿. 无人潜器总体方案设计的多学科优化方法研究[D].哈尔滨: 哈尔滨工程大学, 2012.
YANG Zhuoyi. A study on multidisciplinary design optimization method for scheme design of autonomous underwater vehicle[D]. Harbin: Harbin Engineering University, 2012.
[14]SHU Z, MOAN T. Reliability analysis of a bulk carrier in ultimate limit state under combined global and local loads in the hogging and alternate hold loading condition[J]. Marine Structures, 2011, 24(1): 1-22.
[15]GASPAR B, NAESS A, LEIRA B J, et al. System reliability analysis of a stiffened panel under combined uniaxial compression and lateral pressure loads[J]. Structural Safety, 2012, 39: 30-43. |