带轻载变频模式的升压式DCDC转换器设计

摘要/Abstract

摘要： 分析了传统升压式DCDC转换器在全负载范围内实现高电源转换效率的局限性，在此基础上，提出了一种轻载检测和自适应变频机制.该技术无需额外的芯片管脚和器件，即能使转换器在电感电流断续模式下精确检测出负载状况.将所设计的升压式DCDC转换器在CZ6H 0.35 μm标准CMOS工艺条件下进行仿真.结果表明，当负载电流发生变化时，转换器能够根据负载检测值的大小自适应地进行跳频变换.在负载电流为1 mA的条件下，电源转换效率达到82%.系统环路能够在全负载范围内保持良好的稳定性，当负载电流以1.5μA/20μs跳变时，最大下冲和上冲电压分别为300和200 mV，恢复时间分别只需80和60 μs，版图面积约为1.26 mm2.

关键词: , 瞬态响应, 相位裕度, 变频模式, 电感电流取样, 电源转换效率

Abstract: This paper analyzes the high power conversion efficiency limit at full load range of traditional boost DCDC converter. Based on the analysis, light load detector and adaptive frequency hopping mechanism are put forward. The proposed technique doesn’t need additional pad and device while the load condition can be accurately detected in the Discontinuous Conduction Mode (DCM) of inductor current. The proposed boost DCDC converter is simulated in the CZ6H 0.35μm standard CMOS process, and results show that the proposed converter can adaptively select control frequency according to the load detector. At the load condition of 1 mA, power conversion efficiency can be up to 82%. System feedback loop can keep well stable within a wide range of load variation. For a load step of 1.5μA/20μs, the circuit has a maximum undershoot of 300mV and a maximum overshoot of 200mV. The recovery time is only 80μs and 60μs respectively，and the layout area is about 1.26mm2.

Key words: , transient response；phase margin；frequency hopping mode；inductor current sensor；power conversion efficiency

中图分类号:

TN 433

胡佳俊，陈后鹏，王倩，李喜，苗杰，雷宇，宋志棠. 带轻载变频模式的升压式DCDC转换器设计[J]. 上海交通大学学报（自然版）, 2017, 51(6): 658-664.

HU Jiajun,CHEN Houpeng,WANG Qian,LI Xi,MIAO Jie,LEI Yu,SONG Zhitang. Design of Boost DCDC Converter with
Frequency Hopping at Light Load[J]. Journal of Shanghai Jiaotong University, 2017, 51(6): 658-664.

参考文献

［1］CHEUNG F L, PHILIP K T M. A monolithic currentmode CMOS DCDC converter with onchip currentsensing technique［J］. IEEE Journal of SolidState Circuits, 2004, 39(1): 314.
［2］CHI Y L, PHILIP K T M. A 1V integrated currentmode boost converter in standard 3.3/5V CMOS techniques ［J］. IEEE Journal of SolidState Circuits, 2005, 40(11): 22652274.
［3］MA F F, CHEN W Z. A monolithic currentmode buck converter with advanced control and protection circuits［J］. IEEE Transactions on Power Electronics, 2007, 22(5): 18361846.
［4］LEE C S, OH Y J. Integrated BiCMOS control circuits for highperformance DCDC boost converter［J］. IEEE Transactions on Power Electronics, 2012, 28(5): 25962603.
［5］LIU J M, WANG P Y. A currentmode DCDC buck converter with efficiencyoptimized frequency control and reconfigurable compensation［J］. IEEE Transactions on Power Electronics, 2012, 27(2): 869880.
［6］CHEN K H, CHANG C J. Bidirectional currentmode capacitor multipliers for onchip compensation ［J］. IEEE Transactions on Power Electronics, 2008, 23(1): 180188.
［7］JING X C, PHILIP K T M. A fast fixedfrequency adaptiveontime boost converter with light load efficiency enhancement and predictable noise spectrum ［J］. IEEE Journal of SolidState Circuits, 2013, 48(10): 24422456.
［8］TSAI C H, TSAI Y S. A stable modetransition technique for a digitally controlled noninverting buckboost DCDC converter［J］. IEEE Transactions on Industrial Electronics, 2015, 62(1): 475483.
［9］LIU P J, HSU C Y. Techniques of dualpath error amplifier and capacitor multiplier for onchip compensation and softstart function［J］. IEEE Transactions on Power Electronics, 2015, 30(3): 14031410.
［10］HUANG C, PHILIP K T M. Undershoot suppression technique for fully integrated pulsewidth modulated switching converters［J］. Electronics Letters, 2015, 51(1): 9697.

编辑推荐

Metrics

阅读次数

全文

HTML			PDF

最新录用	在线预览	正式出版	最新录用	在线预览	正式出版
0	0	0	4	0	76

来源	本网站	其他网站

次数	29	51
比例	36%	64%

摘要

613

最新录用	在线预览	正式出版

68	0	545

[1]	王聚团, 戚晓宁, 黄志明. 水下生产管汇测试技术及其改进研究[J]. 海洋工程装备与技术, 2022, 9(2): 43-49.
[2]	袁振钦, 邹科, 孙亚峰, 刘刚, 屈衍, 李居跃. 基于时域分析法的动态电缆疲劳分析[J]. 海洋工程装备与技术, 2022, 9(2): 50-55.
[3]	王娟, 杨明旺, 郑茂尧, 刘凌云, 赵立君. 高强钢在大型半潜式平台组块建造中的应用[J]. 海洋工程装备与技术, 2022, 9(1): 27-31.
[4]	陈欣, 赵晓磊, 王立坤, 肖德明, 张腾月. 深水大型吸力锚建造技术研究[J]. 海洋工程装备与技术, 2022, 9(1): 32-36.
[5]	尹彦坤, 易涤非. 半潜式生产平台船体结构关键节点工程临界评估[J]. 海洋工程装备与技术, 2022, 9(1): 52-57.
[6]	ZHANG Shengfa (张胜发), TANG Na (唐纳), SHEN Guofeng (沈国峰), WANG Han (王悍), QIAO Shan (乔杉). Universal Software Architecture of Magnetic Resonance-Guided Focused Ultrasound Surgery System and Experimental Study[J]. J Shanghai Jiaotong Univ Sci, 2021, 26(4): 471-481.
[7]	MA Qunsheng (马群圣), CEN Xingxing (岑星星), YUAN Junyi (袁骏毅), HOU Xumin (侯旭敏). Word Embedding Bootstrapped Deep Active Learning Method to Information Extraction on Chinese Electronic Medical Record[J]. J Shanghai Jiaotong Univ Sci, 2021, 26(4): 494-502.
[8]	KONG Xiangqiang (孔祥强), MENG Xiangxi (孟祥熙), LI Jianbo (李见波), SHANG Yanping (尚燕平), CUI Fulin (崔福林) . Comparative Study on Two-Stage Absorption Refrigeration Systems with Different Working Pairs[J]. J Shanghai Jiaotong Univ Sci, 2021, 26(2): 155-162.
[9]	ZHUANG Weimin (庄蔚敏), WANG Pengyue (王鹏跃), AO Wenhong (熬文宏), CHEN Gang (陈刚) . Experiment and Simulation of Impact Response of Woven CFRP Laminates with Different Stacking Angles[J]. J Shanghai Jiaotong Univ Sci, 2021, 26(2): 218-230.
[10]	安庆升, 孙立东, 武秋生. 碳纤维增强复合材料发射筒设计研究[J]. 空天防御, 2021, 4(2): 13-.
[11]	ZHOU Xuhui (周旭辉), ZHANG Wenguang (张文光), XIE Jie (谢颉). Effects of Micro-Milling and Laser Engraving on Processing Quality and Implantation Mechanics of PEG-Dexamethasone Coated Neural Probe[J]. J Shanghai Jiaotong Univ Sci, 2021, 26(1): 1-9.
[12]	HUANG Ningning (黄宁宁), MA Yixin (马艺馨), ZHANG Mingzhu (张明珠), GE Hao (葛浩), WU Huawei (吴华伟). Finite Element Modeling of Human Thorax Based on MRI Images for EIT Image Reconstruction[J]. J Shanghai Jiaotong Univ Sci, 2021, 26(1): 33-39.
[13]	WANG Xianjin, GAO Xu, YU Kuigang . Fixture Locating Modelling and Optimization Research of Aluminum Alloy Sidewall in a High-Speed Train Body[J]. J Shanghai Jiaotong Univ Sci, 2020, 25(6): 706-713.
[14]	QIAO Xing, MA Dan, YAO Xuliang, FENG Baolin. Stability and Numerical Analysis of a Standby System[J]. J Shanghai Jiaotong Univ Sci, 2020, 25(6): 769-778.
[15]	WU Jin, MIN Yu, YANG Xiaodie, MA Simin . Micro-Expression Recognition Algorithm Based on Information Entropy Feature[J]. Journal of Shanghai Jiao Tong University(Science), 2020, 25(5): 589-599.