考虑侧壁效应修正的循环水槽船模斜航试验水动力计算

摘要/Abstract

摘要：

采用计算流体动力学技术，以KVLCC2船模为对象研究速度修正方法对斜航水动力修正的影响及其适用工况，并与循环水槽试验结果对比以验证速度修正方法的有效性；采用Tamura速度修正公式对宽阔水域的试验流速进行修正，将速度修正前后的水动力及流场特征与循环水槽斜航试验的计算结果进行对比.结果表明：Tamura速度修正公式在阻塞比为3.5%~5.0%时有效，阻塞比过大将会加大船体两侧流场流速的变化；循环水槽中船体两侧的压力分布与其在宽阔水域中的差别较大；速度修正方法会同时增大船体两侧的压力，因此，在一定的阻塞比范围内可以减小两者的水动力差异，但当阻塞比继续增大时会增大两者的水动力差异.同时，基于低速风洞试验的阻塞效应修正方法提出了低速肥大型船循环水槽斜航试验的横向水动力修正公式.

关键词: , 循环水槽, 斜航试验, 侧壁效应, 速度修正, 数值计算

Abstract:

The characteristics and applicable conditions of a velocity correction method to account for the correction of hydrodynamic forces are investigated by applying computational fluid dynamics (CFD) technique to oblique towing tests of a KVLCC2 model. The results of numerical method are verified by comparing with the test results in a circulating water channel (CWC). Tamura’s formula on velocity correction is appied to obtain new velocities for tests in wide flow field. Comparisons between hydrodynamics and flow field of the corrected or noncorrected condition and those of CWC test show that Tamura’s formula is applicable to the blockage range of 3.5%－5.0%, while larger blockage leads to drastic changes of flow velocity around the ship. Remarkable difference of the pressure distribution exists along with two sides of the model ship between the tests in CWC and that in wide flow field. The velocity correction increases the pressure of both sides, therefore it reduces the discrepancy within certain blockage ratios and enlarges discrepancy as the ratio continuonsly grows. Meanwhile, correction formula of the lateral hydrodynamic force for low speed fullform ships is proposed based on the blockage correction in a low speed wind tunnel.

Key words: circulating water channel (CWC), oblique towing test, side wall effect, velocity correction, numerical method

中图分类号:

U 661.3

刘晗a，马宁b,c，顾解忡b,c. 考虑侧壁效应修正的循环水槽船模斜航试验水动力计算[J]. 上海交通大学学报（自然版）, 2017, 51(2): 142-.

LIU Hana,MA Ningb,c,GU Xiechongb,c. Calculation of the Hydrodynamic Forces of Ship Model Oblique Towing Test in Circulating Water Channel by Considering Side Wall Effect Correction[J]. Journal of Shanghai Jiaotong University, 2017, 51(2): 142-.

参考文献

［1］SHOJI K. PMM tests in a circulating water channel and nonlinear analysis ［J］. Journal of Marine Science and Technology, 2002, 7(2): 86-90.
［2］BAI J L, MA N, GU X C. Evolution and energy transition of focused waves on current ［C］∥34th International Conference on Ocean, Offshore and Arctic Engineering. St. John’s, Canada: American Society of Mechanical Engineers, 2015.
［3］HASHIZUME Y, MATSUI S. On PMM tests in a circulating water channel ［J］. West Jpn Soc Nav Archit, 1994， 87: 119-124.
［4］TAMASHIMA M, MATSUI S, OGURA M. Quantitative measurements with small models of ships in a circulating water channel ［J］. Experiments in Fluids, 1983, 1(3): 135-142.
［5］GROSS A, WATANABE K. On blockage correction［C］∥Proceedings of 13th ITTC. Berlin: ITTC, 1972: 209-240.
［6］TAMURA K. Study on the blockage correction ［J］. Journal of the Society of Naval Architects of Japan, 1972, 131: 17-28.
［7］TAO X, BHUSHAN S, STERN F. Vortical and turbulent structures for KVLCC2 at drift angle 0, 12, and 30 degrees ［J］. Ocean Engineering, 2010, 55(1): 678-687.
［8］LIU H, MA N, GU X C. Maneuvering prediction of a VLCC model based on CFD simulation for PMM tests by using a circulating water channel ［C］∥34th International Conference on Ocean, Offshore and Arctic Engineering. St. John’s, Canada: American Society of Mechanical Engineers, 2015.
［9］CHEN X, LU C J, LI J, et al. The wall effect on ventilated cavitating flows in closed cavitation tunnels ［J］. Journal of Hydrodynamics, 2008, 20(5): 561-566.
［10］周景军，李荣融，项庆睿, 等. 通气超空泡水洞试验阻塞效应影响研究［J］. 水动力学研究与进展(A辑), 2014, 29(3): 361-366.
ZHOU Jingjun, LI Rongrong, XIANG Qingrui, et al. Research on the influence of blockage in water tunnel for ventilated supercavitating flow ［J］. Chinese Journal of Hydrodynamics A, 2014, 29(3): 361-366.
［11］刘彦伟，刘莹. 水洞试验中阻塞比对阻力测量影响的数值模拟［J］. 试验技术与管理, 2007, 24(12): 44-47.
LIU Yanwei, LIU Ying. Numerical simulation of the effect of blockage ratio on drag measurement in water tunnel test ［J］. Experimental Technology and Management, 2007, 24(12): 44-47.
［12］PEITZMAN F W. Determination of high attitude wall corrections in a low speed wind tunnel ［C］∥Proceedings of 10th Aerodynamic Testing Conference. San Diego, USA: American Institute of Aeronautics and Astronautics, 1978: 13-18.
［13］KUME K, HASEGAWA J, TSUKADA Y, et al. Measurements of hydrodynamic forces, surface pressure, and wake for obliquely towed tanker model and uncertainty analysis for CFD validation［J］. Journal of Marine Science and Technology, 2006, 11(2): 65-75.
［14］ITTC Manoeuring Committee. Testing and extrapolation methods, manoeuvrability, captive model test procedures: ITTCrecommended procedures and guidelines: 7.5-06-02-02［S］. Fukuoka, Japan: ITTC Manoeuring Committee, 2008.
［15］杨勇. 非定常操纵运动船体水动力数值计算［D］. 上海: 上海交通大学船舶海洋与建筑工程学院, 2011.
［16］SALIM S M, CHEAH S C. Wall y+ strategy for dealing with wallbounded turbulent flows ［C］∥Proceedings of the International MultiConference of Engineers and Computer Scientists. Hong Kong：IMECS, 2009.

[1]	赵忠良, 李浩, 赖江, 杨海泳, 王晓冰, 李玉平. 导弹模型直气复合气动特性研究[J]. 空天防御, 2022, 5(3): 1-9.
[2]	王聚团, 戚晓宁, 黄志明. 水下生产管汇测试技术及其改进研究[J]. 海洋工程装备与技术, 2022, 9(2): 43-49.
[3]	袁振钦, 邹科, 孙亚峰, 刘刚, 屈衍, 李居跃. 基于时域分析法的动态电缆疲劳分析[J]. 海洋工程装备与技术, 2022, 9(2): 50-55.
[4]	王娟, 杨明旺, 郑茂尧, 刘凌云, 赵立君. 高强钢在大型半潜式平台组块建造中的应用[J]. 海洋工程装备与技术, 2022, 9(1): 27-31.
[5]	陈欣, 赵晓磊, 王立坤, 肖德明, 张腾月. 深水大型吸力锚建造技术研究[J]. 海洋工程装备与技术, 2022, 9(1): 32-36.
[6]	尹彦坤, 易涤非. 半潜式生产平台船体结构关键节点工程临界评估[J]. 海洋工程装备与技术, 2022, 9(1): 52-57.
[7]	程晨, 王晓亮. 考虑蒙皮透射率的飞艇热力学模型及其热特性[J]. 上海交通大学学报, 2021, 55(7): 868-877.
[8]	王超, 杨波, 汪春辉, 郭春雨, 徐佩. 螺旋桨抽吸作用下冰块运动轨迹[J]. 上海交通大学学报, 2021, 55(5): 505-512.
[9]	MA Qunsheng (马群圣), CEN Xingxing (岑星星), YUAN Junyi (袁骏毅), HOU Xumin (侯旭敏). Word Embedding Bootstrapped Deep Active Learning Method to Information Extraction on Chinese Electronic Medical Record[J]. J Shanghai Jiaotong Univ Sci, 2021, 26(4): 494-502.
[10]	ZHANG Shengfa (张胜发), TANG Na (唐纳), SHEN Guofeng (沈国峰), WANG Han (王悍), QIAO Shan (乔杉). Universal Software Architecture of Magnetic Resonance-Guided Focused Ultrasound Surgery System and Experimental Study[J]. J Shanghai Jiaotong Univ Sci, 2021, 26(4): 471-481.
[11]	安庆升, 孙立东, 武秋生. 碳纤维增强复合材料发射筒设计研究[J]. 空天防御, 2021, 4(2): 13-.
[12]	KONG Xiangqiang (孔祥强), MENG Xiangxi (孟祥熙), LI Jianbo (李见波), SHANG Yanping (尚燕平), CUI Fulin (崔福林) . Comparative Study on Two-Stage Absorption Refrigeration Systems with Different Working Pairs[J]. J Shanghai Jiaotong Univ Sci, 2021, 26(2): 155-162.
[13]	ZHUANG Weimin (庄蔚敏), WANG Pengyue (王鹏跃), AO Wenhong (熬文宏), CHEN Gang (陈刚) . Experiment and Simulation of Impact Response of Woven CFRP Laminates with Different Stacking Angles[J]. J Shanghai Jiaotong Univ Sci, 2021, 26(2): 218-230.
[14]	ZHOU Xuhui (周旭辉), ZHANG Wenguang (张文光), XIE Jie (谢颉). Effects of Micro-Milling and Laser Engraving on Processing Quality and Implantation Mechanics of PEG-Dexamethasone Coated Neural Probe[J]. J Shanghai Jiaotong Univ Sci, 2021, 26(1): 1-9.
[15]	HUANG Ningning (黄宁宁), MA Yixin (马艺馨), ZHANG Mingzhu (张明珠), GE Hao (葛浩), WU Huawei (吴华伟). Finite Element Modeling of Human Thorax Based on MRI Images for EIT Image Reconstruction[J]. J Shanghai Jiaotong Univ Sci, 2021, 26(1): 33-39.