环形流道内周向流对摩擦因子的修正公式

摘要/Abstract

摘要：

摘要：针对屏蔽电动机定转子环形流道内转子转动对其摩擦因子的影响作定量分析.搭建缩尺实验台，实验分析了不同转子转速下定转子间的压力分布规律.实验结果表明：转速的升高会引起压降增大，间隙环流的摩擦因子需要在经验公式上进行修正，分析拟合数据得到了修正系数与切向、轴向雷诺数比值的映射关系，从而推导出了环形流道内考虑周向流动下摩擦因子的修正公式.为了验证该公式的准确性与普遍性，利用计算流体动力学(CFD)软件对缩尺实验台与主泵屏蔽电动机定转子间的流场分别进行仿真，对比数值仿真与该修正公式所求得的摩擦因子，结果表明偏差在合理范围内.

关键词: 环形流道, 摩擦因子, 修正公式, 周向流, 屏蔽泵, 计算流体动力学

Abstract:

Abstract： This paper aimed to find out the law of friction factor relative to the parameter of rotor rotating in the annular channel between the rotor and the stator of the canned pump. The distributions of pressure drop at different rotor speeds were measured by a scale test rig. The experimental results indicated that with the rotational speed increasing, the pressure drop between the inlet and the outlet also increases, and the original empirical formula of friction factor in an annulus channel is no longer suitable and should be revised. The function relationship between the revision factor and ratio of tangential/axial Reynold numbers was obtained by using data analysis. Thus, the revised formula of friction factor affected by tangential flow was derived. In order to verify the accuracy and universality of this formula, the flow characteristics and pressure drop of the fluid in the scale test rig and in the canned pump were studied by using the computational fluid dynamics (CFD) method. The results showed that the bias of the friction factor calculated by simulation and the revised formula is small enough to be considered in a reasonable range.

Key words: annular channel, friction factor, revised formula, tangential flow, canned pump, computational fluid dynamics (CFD)

中图分类号:

TK 72

张磊华a，姚振强a,b，沈洪a,b，成德a，薛亚波a. 环形流道内周向流对摩擦因子的修正公式[J]. 上海交通大学学报（自然版）, 2017, 51(1): 46-.

ZHANG Leihuaa，YAO Zhenqianga,b，SHEN Honga,b，CHENG Dea，XUE Yaboa. Revised Formula for Friction Factor Affected by Tangential Flow in an Annular Channel[J]. Journal of Shanghai Jiaotong University, 2017, 51(1): 46-.

参考文献

［1］孙汉虹.第三代核电技术AP1000 ［M］. 北京:中国电力出版社，2010:347-375.
［2］COLEBROOK C F. Turbulent flow in pipes, with particular reference to the transition region between the smooth and rough pipe laws ［J］. Journal of the ICE, 1939, 11(4): 133-156.
［3］ROTHFUS R R, MONRAD C C, SENECAL V E. Velocity distribution and fluid friction in smooth concentric annuli ［J］. Industrial & Engineering Chemistry, 1950, 42(12): 2511-2520.
［4］WARRIER G R, DHIR V K, MOMODA L A. Heat transfer and pressure drop in narrow rectangle channels ［J］. Experimental Thermal and Fluid Science, 2002, 26(1): 53-64.
［5］KARWA R, SOLANKI S C, SAINI J S. Heat transfer coefficient and friction factor correlations for the transitional flow regime in ribroughened rectangular ducts ［J］. International Journal of Heat and Mass Transfer, 1999, 42(9): 1597-1615.
［6］EIAMSAARD S, THIANPONG C, PROMVONGE P. Experimental investigation of heat transfer and flow friction in a circular tube fitted with regularly spaced twisted tape elements ［J］. International Communications in Heat and Mass Transfer, 2006, 33(10): 1225-1233.
［7］KANEDA M, YU B, OZOE H, et al. The characteristics of turbulent flow and convection in concentric circular annuli flow ［J］. International Journal of Heat and Mass Transfer, 2003, 46(26): 5045-5057.
［8］孔繁余，高翠兰，张旭峰，等. PBN6540250 型屏蔽泵轴向力平衡计算及其试验［J］.农业工程学报，2009，25(5): 68-72.
KONG Fanyu, GAO Cuilan, ZHANG Xufeng, et al. Computation and experiment for axial force balance of canned motor pump PBN6540250［J］. Transactions of the Chinese Society of Agricultural Engineering, 2009, 25(5):68-72.
［9］孔祥花,孔繁余,季建刚,等. 屏蔽泵冷却润滑回路分析计算［J］.水泵技术,2006(5):8-10.
KONG Xianghua, KONG Fanyu, JI Jiangang,et al. The analysis computation of cooling the lubrication loop in canned motor pump ［J］. Pump Technology, 2006 (5):8-10.
［10］李伟,施卫东,蒋小平,等. 屏蔽泵轴向力平衡新方法［J］. 农业工程学报,2012,28(7):86-90.
LI Wei, SHI Weidong, JIANG Xiaoping, et al. New method for axial force balance of canned motor pump［J］. Transactions of the Chinese Society of Agricultural Engineering, 2012, 28(7): 86-90.
［11］成德,薛亚波,沈洪,等. 屏蔽式电动泵内部流场的分析与可视化［J］. 核科学与工程,2013,33(4):398-403.
CHENG De, XUE Yabo, SHEN Hong, et al. The calculation and visualization of the fluid field in the canned pump［J］. Nuclear Science and Engineering, 2013, 33(4): 398-403.
［12］华绍曾,杨学宁. 实用流体阻力手册［M］. 北京:国防工业出版社，1985:96-97.

[1]	宋深科, 夏立, 邹早建, 邹璐. 大型邮轮与集装箱船水动力相互作用数值研究[J]. 上海交通大学学报, 2022, 56(7): 919-928.
[2]	孙健, 彭斌, 朱兵国. 无油双涡圈空气涡旋压缩机的数值模拟及试验研究[J]. 上海交通大学学报, 2022, 56(5): 611-621.
[3]	杨梦姚, 毛璐璐, 韩兆龙, 周岱, 雷航, 曹宇. 三叶片H型垂直轴风力机风振与减振研究[J]. 上海交通大学学报, 2021, 55(4): 347-356.
[4]	徐野, 熊鹰, 黄政. 双桨船螺旋桨空泡脉动压力的试验及数值研究[J]. 上海交通大学学报, 2020, 54(8): 831-838.
[5]	夏立, 邹早建, 袁帅, 曾智华. 基于非侵入式混沌多项式法的随机阻曳流CFD模拟不确定度量化[J]. 上海交通大学学报, 2020, 54(6): 584-591.
[6]	郭军，陈作钢，戴原星，陈建平. 喷水推进器进流面获取方法及其应用[J]. 上海交通大学学报, 2020, 54(1): 1-9.
[7]	谢行，任慧龙，陶凯东，冯亿坤. 应用改进流体体积法的楔形体斜向入水研究[J]. 上海交通大学学报, 2020, 54(1): 20-27.
[8]	李亮，解茂昭，贾明，刘宏升. 超临界射流模型的构建及验证[J]. 上海交通大学学报（自然版）, 2018, 52(9): 1058-1064.
[9]	冯岩，饶宇，李博. 凹陷涡发生器形状对湍流流动与传热性能的影响[J]. 上海交通大学学报（自然版）, 2015, 49(05): 614-619.
[10]	马超，臧述升，陈小岭，吉雍斌. V形肋通道内蒸汽冷却的传热及流动特性[J]. 上海交通大学学报（自然版）, 2015, 49(05): 644-650.
[11]	冯松波a，邹早建a,b，邹璐a. KVLCC2船-舵系统斜航水动力数值计算[J]. 上海交通大学学报（自然版）, 2015, 49(04): 470-474.
[12]	徐博1，张驰1，陈江平1，孙西辉2，马小魁2. 积液型两相流分配器的性能与优化[J]. 上海交通大学学报（自然版）, 2015, 49(01): 91-95.
[13]	韩龙1，陈阳陵2，王福新1，程用胜1. 高海况机翼波浪地面效应数值模拟与分析[J]. 上海交通大学学报（自然版）, 2014, 48(08): 1127-1133.
[14]	胡晓晨, 祁照岗, 殷礼鸣, 陈江平. 新型金属氢化物反应床传热性能分析[J]. 上海交通大学学报（自然版）, 2012, 46(04): 530-535.
[15]	桂晓澜, 周岱, 李俊龙. 基于计算流体动力学法的风场模拟和流/固耦合问题[J]. 上海交通大学学报（自然版）, 2012, 46(01): 158-166.